Axalta Corlar 2.1-ST DTM Primer Base

AXALTA IMRON CORLAR 2.1-ST SATIN HIGH SOLIDS EPOXY MASTIC – PART “A” ONLY  Corlar® 2.1-ST™ is a light gray satin gloss, high build epoxy mastic, two-package, VOC conforming product (2.1 lbs/gal)* based on Axalta amido amine modified polyamide epoxy technology. The resulting highly durable coating delivers outstanding corrosion and chemical resistance. Product is sold by the gallon.

As a high performance direct-to-metal (DTM) coating or topcoat on carbon steel, galvanized steel, stainless steel, aluminum, concrete, concrete block and wood where:

• Rusted, hand or power-tool cleaned surfaces must be protected.
• Single coat applications up to 10 mils dry film thickness are required.
• Application will be made over damp surfaces and/or under conditions of high relative humidity.
• Excellent resistance to chemical and/or marine environments is required.
• Outstanding abrasion resistance and edge protection are required.
• Application by brush and roller, in addition to spraying, may be necessary.
• Application must be made at temperatures as low as 35°F.
• No induction time and long pot life will improve productivity.

Corlar® 2.1-ST™ may also be used as a high performance tank lining on carbon steel or concrete for immersion service in near neutral pH water, fresh water, or saltwater. Corlar® 2.1-ST™ is not recommended for use with potable water. Contact your Axalta Performance Coatings Representative for specific immersion service recommendations and procedures.

MIX RATIO

Thoroughly mix 1 parts Imron® 2.1 ST™, then add 1 part of Imron® VF-525 Activator (sold separately). Mix well by stirring with mechanical mixer. Do not shake. No induction period is necessary.

SHIPPING NOTE: Product is considered hazardous if shipping by air.

LINKS:

Axalta Corlar 2.1ST DTM Satin Epoxy Primer – TDS

Axalta Corlar 2.1ST DTM Satin Epoxy Primer LF-63725P Base – SDS